

Change or rekey · Lisgar
Smart Lock Installation in Lisgar
You have just taken possession of the house and the previous owners handed over a keypad deadbolt with a code nobody wrote down and an app account you cannot get into.
In plain words
The first decision is which kind of smart lock suits the door and the household. A keypad deadbolt that keeps the existing keyway is the simplest swap and keeps a familiar key as backup. A lock that talks to your phone over Bluetooth works when you are standing at the door; adding Wi-Fi or a small bridge lets you check and change it from anywhere. Some models bolt onto the inside of the door and turn the deadbolt you already have, so the outside is untouched. A locksmith matches these choices to the door's thickness, how it hangs and the network strength at the entrance.
How the visit goesThere are four copies of the front-door key floating around: one with the cleaner, one with a neighbour, one on a hook at your parents' place, and one you honestly cannot account for. You would rather hand out codes you can switch off.
Smart Lock Installation
How the visit goes


Measuring the door and its holes
Smart locks are built around the standard residential preparation, so the locksmith measures before choosing. Door thickness is usually between 35 and 45 millimetres; thicker doors need an extension kit and very thin ones may need a different model. The large cross bore for the cylinder, the smaller edge bore for the bolt and the backset from the door edge to the centre of the hole are each checked against the new lock's range. A lever set also needs the handing confirmed. Steel and fibreglass doors, doors with a mortise pocket from an older lock, and doors with glass close to the handle each change what will fit and how it is mounted.
Retrofit locks that keep your outside hardware
Some smart locks mount only on the inside of the door and turn the deadbolt you already own, leaving the exterior face and the keyway as they were. Fitting one begins by checking that the existing deadbolt is on the model's compatibility list and that its tailpiece shape matches an adapter in the box. The interior thumb-turn is removed, the adapter fitted, and the motor unit clamped to the mounting plate so it sits square and turns the bolt through its full travel without slipping. Because the outside is untouched, these suit rented units where the landlord prefers the door unchanged, and older doors whose exterior hardware is worth keeping. The existing key keeps working alongside the phone.
Keeping the lock healthy through the seasons
A smart lock asks for a little seasonal attention and rewards it. In spring and autumn, check that the bolt still glides with the door closed and no hand on it; a door that has swollen or dropped starts to strain the motor before it stops working, and a hinge screw or strike adjustment then is far easier than a call later. Keep the keypad free of ice and grit, wipe salt film off the exterior in winter, and use only a dry lubricant on the override cylinder, never oil. Accept firmware updates when the app offers them. If the lock starts to sound laboured, that is its way of asking for a look.
Smart Lock Installation
In the van
Door-position sensor magnet
Manufacturer-specified batteries
Smart deadbolt or smart lever set
Hand screwdrivers, Phillips and Torx
Hinge shims and long hinge screws

Smart Lock Installation
What affects the quote
Retrofit versus full replacement
An interior-only unit that turns your existing deadbolt involves less door work than a complete new deadbolt with a keypad outside, and the two are quoted differently in both hardware and time.
Pairing a smart deadbolt with a smart lever on the same door
Some doors get a smart deadbolt only, while others pair it with a smart lever below so both turn from one app and share the same codes. Fitting and programming two devices on one door takes more work than one, confirmed once the door and hardware are seen.
Type of smart lock chosen
A keypad deadbolt, a Bluetooth model, a Wi-Fi model with a built-in radio or a lock that joins a home hub each sit at a different point on the hardware side of the quote, before any labour is counted.
What to have ready
- How strong is the Wi-Fi signal when you stand at that door?
- Roughly how thick is the door?
- Should the door lock itself after it closes?
Smart Lock Installation: questions
QuestionsThe house came with a smart lock. Can you make it mine?
Yes, and it is treated as a fresh installation rather than a hand-me-down. The lock is reset to factory settings using the maker's procedure, which wipes codes, schedules and paired phones, then enrolled to an account you create. Anything else that could open it, such as a hub or a voice assistant, gets its own check, because those permissions sit outside the lock. The override cylinder is rekeyed, batteries replaced and firmware updated. If the hardware is worn, replacing it is the cleaner choice.
Fingerprint, fob, code or phone: which is worth having?
It depends on who uses the door. Codes suit everyone and need nothing in hand. Fobs or cards are a favourite for children and for anyone who finds small buttons difficult, since a tap does it. Fingerprint readers are convenient for a household of adults but can be fussy with cold, wet or gloved hands in winter, so pair them with a code. Phone control is for whoever wants alerts and remote checks. Most families end up using two of these.
I rent. Can I have a smart lock installed?
Yes, with your landlord's agreement first. Tenancy rules in this province expect a tenant to have the landlord's consent before changing a lock, and expect the landlord to have a working way in, so the sensible route is a short conversation and a note of what will be fitted. A retrofit model that mounts inside and keeps the existing exterior lock and key is often the easiest thing for a landlord to say yes to, since the door is unchanged from outside.
Related services

- Deadbolt InstallationThe old deadbolt has grown lazy.
- Lock Replacement & UpgradeThe brass handleset has gone blotchy and green where the winter salt reaches it, and the coating on the deadbolt is lifting in flakes.
- Vintage Mortise Lock ServiceSomeone painted the door years ago without removing the hardware.